[. . . ] [. . . ] (See Tech Note) DooDad® ® Coupling Ring STEP 5 Solder tip to center conductor here Connector Body Solder braid to connector body through holes Slide DooDad Cable Strain Relief, coupling ring and reducing adapter onto the cable in the order and orientation shown. Outer Jacket STEP 2 ¾" Prepare the cable according to the dimensions shown above. 3 (See Tech Note) Screw the reducing adapter into the connector body tightly and solder the tip to the center conductor. Trim off any excess center conductor and solder the braid to the body through the holes. Slide the DooDad® Cable Strain Relief snugly onto the rear of the completed connector. /8" STEP 3 TECH NOTE If you prefer a complete solder installation, do not use the metal washer or Teflon spacer. At Step 5, solder the tip, and then solder the braid to the connector body through the four small holes in the connector body. [. . . ] [. . . ]